Search for videos on all aspects of woodworking that interest you and collect them. Hope it helps you as much as they did me.ġ) If you are using Firefox browser, get a free add on YouTube download helper app. These are the 17+ things that really helped me get going with woodworking. The following has been posted before so those who have read it before may wish to skip it. Hopefully it will get you going without spending a ton of money. Later I'll post a long piece on getting started. Cut an opening by pulling it into the router (slowly). It's cheap.įor a fence, you can simply use a very straight section of knot free 2x4 (kiln dried). BTW, I think you have to order a metal key to adjust the Bosch's height from above the table. But if you're interested in some early projects you can make a simple cabinet. You don't need a formal table to hold the top, you can put it across a couple of saw horses. I think Kreg now has this kind of twist lock plate. Most cheaper mounting plates have screws holding the inserts, which are easy to lose and annoying to mess with. I added a picture of my choice of mounting plate, made by Woodpecker, which has simple twist lock inserts (the red rings). Better to have the mounting plate slightly higher than have it even slightly lower. The leveling screws are for bringing the plate precisely level with the top. Personally, I'd cut the opening in the second layer a half inch smaller on all 4 sides to give yourself a shelf or rabbet the plate will sit on. I prefer a two layer table, with the second or bottom layer made of MDF or fery flat ply. I hope Stick will post his collection of pdfs shortly. It is easier than you think it will be and will give you a little practice. You cut out the rough opening an eighth of an inch smaller, then use a trim bit with a bearing on the base to rout the opening using the four boards as a guide you run the bearing against. Use playing cards to add just a little wiggle room or you'll have problems getting the plate in or out later. You put the plate where you want it and set four flat boards around it as shown in the drawing. Cutting the opening is usually done with a jig saw in a one or preferably two layers of very flat ply. I think Kreg has a modest priced mounting plate made of phenolic plastic.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |